Maytag MGD6500MW Gas dryer
Troubleshooting, fault codes and repair information for the Maytag MGD6500MW, organized around the engineering platform this gas dryer is built on.
- Brand
- Maytag
- Model
- MGD6500MW
- Engineering revisions
- MGD6500MW0, MGD6500MW1
- Appliance
- Gas dryer
- Platform
- Gas dryer platform, documentation from about 2021
- Models on this platform
- 9 across Crosley, Maytag, Whirlpool
- Documented fault codes
- 8 with explanations
- Service diagnostic mode
- Yes — a console-only test mode used by technicians to read stored codes and run component tests
- Service documentation
- Tech sheet, service manual (used by our technicians; not published)
Maytag MGD6500MW error codes
These are the fault codes documented for the platform this model belongs to. A code describes a condition the control detected; it does not by itself identify a failed part. Select a code for causes, safe checks and repair context.
| Code | Meaning | Areas involved |
|---|---|---|
| F1E1 | Main control fault | Main control board, Wiring harness and connectors, Drive motor |
| F2E1 | Stuck button or interface problem | User interface / keypad board |
| F2E2 | User interface internal fault | User interface / keypad board, Wiring harness and connectors |
| F3E1 | Exhaust thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E2 | Moisture sensor fault | Moisture sensor bars, Wiring harness and connectors, Main control board |
| F3E3 | Inlet thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E5 | Second (rear) moisture sensor fault | Moisture sensor bars, Wiring harness and connectors |
| F6E1 | Communication error (control and interface) | Wiring harness and connectors, User interface / keypad board, Main control board |
Common dryer problems
- Not heating
Documented check order on this platform: Heating element → Main control board - Not starting
Documented check order on this platform: Power supply to the appliance → Wiring and connectors → User interface / keypad → Lid or door switch / lock → Drive belt - Takes too long to dry
Documented check order on this platform: Moisture sensor → Temperature sensor → User interface / keypad → Main control board - Drum not turning
Documented check order on this platform: Drive belt → Power supply to the appliance → Lid or door switch / lock → Drive or pump motor → Main control board - Noisy
- Shuts off early
Documented check order on this platform: Exhaust vent restriction → Heating element → Moisture sensor - Overheating
Documented check order on this platform: Heating element
Typical dryer repair costs
| Repair | Typical range | Labor |
|---|---|---|
| Dryer thermal fuse and thermostat replacement | $180–$310 | Light |
| Gas dryer valve coil or gas valve replacement | $180–$420 | Moderate |
| Gas dryer igniter and flame sensor replacement | $180–$370 | Light |
| Dryer drive motor or blower wheel replacement | $250–$550 | Heavy |
| Dryer drum belt replacement | $180–$320 | Light |
| Dryer drum rollers, glides and idler pulley replacement | $190–$420 | Moderate |
| Dryer moisture sensor bar repair | $180–$310 | Light |
| Dryer door switch replacement | $180–$290 | Light |
| Dryer exhaust thermistor replacement | $180–$290 | Light |
| Dryer main control board replacement | $280–$640 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Repair or replace?
Dryers typically last about 12–14 years. Service documentation for this platform dates from about 2021, so the oldest units built on it are now around 5 years old. The age printed in the serial number, the repair cost and the condition of the rest of the appliance decide it. Use the repair-or-replace guide.
Models built on the same platform
These models share this platform's service documentation, so fault codes and most diagnostic steps are the same.
- Whirlpool WGD500CMW
- Whirlpool WGD500RLW
- Whirlpool WGD5010LW
- Whirlpool WGD5050LW
- Whirlpool WGD6150PB
- Whirlpool WGD6150PW
- Crosley CGD7011LW
- Maytag MGD6500MBK
Need your Maytag MGD6500MW repaired in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.