Maytag MGDE600VO Gas dryer
Troubleshooting, fault codes and repair information for the Maytag MGDE600VO, organized around the engineering platform this gas dryer is built on.
- Brand
- Maytag
- Model
- MGDE600VO
- Engineering revisions
- MGDE600VO0
- Appliance
- Gas dryer
- Platform
- Gas dryer platform, documentation from about 2008
- Models on this platform
- 7 across Maytag
- Documented fault codes
- 2 with explanations
- Service diagnostic mode
- Yes — a console-only test mode used by technicians to read stored codes and run component tests
- Service documentation
- Tech sheet (used by our technicians; not published)
Maytag MGDE600VO error codes
These are the fault codes documented for the platform this model belongs to. A code describes a condition the control detected; it does not by itself identify a failed part. Select a code for causes, safe checks and repair context.
| Code | Meaning | Areas involved |
|---|---|---|
| AF | Restricted airflow | Exhaust vent duct, Blower wheel |
| PF | Power failure | Wiring harness and connectors |
Common dryer problems
Typical dryer repair costs
| Repair | Typical range | Labor |
|---|---|---|
| Dryer thermal fuse and thermostat replacement | $180–$310 | Light |
| Gas dryer valve coil or gas valve replacement | $180–$420 | Moderate |
| Gas dryer igniter and flame sensor replacement | $180–$370 | Light |
| Dryer drive motor or blower wheel replacement | $250–$550 | Heavy |
| Dryer drum belt replacement | $180–$320 | Light |
| Dryer drum rollers, glides and idler pulley replacement | $190–$420 | Moderate |
| Dryer moisture sensor bar repair | $180–$310 | Light |
| Dryer door switch replacement | $180–$290 | Light |
| Dryer exhaust thermistor replacement | $180–$290 | Light |
| Dryer main control board replacement | $280–$640 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Repair or replace?
Dryers typically last about 12–14 years. Service documentation for this platform dates from about 2008, so the oldest units built on it are now around 18 years old. The age printed in the serial number, the repair cost and the condition of the rest of the appliance decide it. Use the repair-or-replace guide.
Models built on the same platform
These models share this platform's service documentation, so fault codes and most diagnostic steps are the same.
Need your Maytag MGDE600VO repaired in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.