Laundry center error codes
Laundry center fault codes documented for Whirlpool-family brands. Where one code has more than one meaning, each is listed with the appliance type it applies to.
| Code | Meaning | Appliance | Brand pages |
|---|---|---|---|
| F0E2 | Oversuds F0E2 means the washer section detected excess suds that it could not clear by flushing. | Laundry center | Whirlpool |
| F0E4 | High water temperature in rinse F0E4 means the washer section found the rinse water hotter than it should be. | Laundry center | Whirlpool |
| F0E5 | Off-balance load F0E5 means the washer section detected an off-balance load during spin. | Laundry center | Whirlpool |
| F0E7 | Low supply voltage (stacked dryer) F0E7 on stacked dryer units means the control measured the incoming supply below the minimum it accepts. | Laundry center | Maytag |
| F1E1 | Main control fault F1E1 means the washer's main control reported an internal fault in its own self-check. | Laundry center | Whirlpool, Maytag |
| F1E1 | Control fault (stacked dryer) F1E1 on stacked dryer units means the control reported a fault in its own circuits or power supply. | Laundry center | Maytag |
| F1E2 | Motor control fault F1E2 means the washer's main control reported a fault in the circuitry that drives the motor. | Laundry center | Whirlpool |
| F1E7 | Control supply input fault (stacked dryer) F1E7 on stacked dryer units means the control found a problem with the power it receives. | Laundry center | Maytag |
| F2E1 | Stuck key F2E1 means a key on the washer's console has read as pressed for an unusually long time. | Laundry center | Whirlpool, Maytag |
| F2E1 | Lower dryer keypad stuck F2E1 on stacked dryer units means a key on the lower dryer's keypad reads as continuously pressed. | Laundry center | Maytag |
| F2E2 | Upper dryer keypad stuck F2E2 on stacked dryer units means a key on the upper dryer's keypad reads as continuously pressed. | Laundry center | Maytag |
| F2E3 | Switch mismatch F2E3 means the console switches do not match what the control expects for this console, or are not working correctly. | Laundry center | Whirlpool |
| F3E1 | Pressure system fault F3E1 means the washer's main control received a water-level (pressure) signal outside the range it considers possible. | Laundry center | Whirlpool |
| F5E1 | Lid switch fault F5E1 means the washer's lid lock reported locked while the lid switch read open, so the control cannot confirm the lid is closed. | Laundry center | Whirlpool, Maytag |
| F5E1 | Lower dryer door circuit F5E1 on stacked dryer units means the control found a problem in the lower dryer's door switch circuit. | Laundry center | Maytag |
| F5E2 | Lid lock fault F5E2 means the washer's lid lock did not move into the locked position, or its motor could not be powered. | Laundry center | Whirlpool |
| F5E3 | Lid unlock fault F5E3 means the washer's lid lock did not move to the unlocked position, so the lid may stay locked. | Laundry center | Whirlpool |
| F5E4 | Lid not opened between cycles F5E4 means the washer was started several times in a row without the lid being opened. | Laundry center | Whirlpool |
| F5E6 | Upper dryer door circuit F5E6 on stacked dryer units means the control found a problem in the upper dryer's door switch circuit. | Laundry center | Maytag |
| F7E1 | Basket speed fault F7E1 means the washer's control could not determine the basket speed, or saw the speed change faster than possible. | Laundry center | Whirlpool |
| F7E5 | Shifter fault F7E5 means the washer's control could not determine the position of the shifter that switches the drive between wash and spin. | Laundry center | Whirlpool |
| F7E6 | Motor fault F7E6 means the washer's control detected an open circuit in the motor's clockwise or counterclockwise drive. | Laundry center | Whirlpool, Maytag |
| F7E6 | Lower dryer motor circuit F7E6 on stacked dryer units means the control found a problem in the lower dryer's motor circuit. | Laundry center | Maytag |
| F7E7 | Motor unable to reach target speed F7E7 means the washer's speed sensor reported that the basket did not reach the target speed. | Laundry center | Whirlpool, Maytag |
| F7E7 | Upper dryer motor circuit F7E7 on stacked dryer units means the control found a problem in the upper dryer's motor circuit. | Laundry center | Maytag |
| F7E8 | Lower dryer motor sense F7E8 on stacked dryer units means the control is not getting the expected feedback that the lower dryer motor is running. | Laundry center | Maytag |
| F7E9 | Upper dryer motor sense F7E9 on stacked dryer units means the control is not getting the expected feedback that the upper dryer motor is running. | Laundry center | — |
| F8E1 | No fill / long fill F8E1 means the washer section has been filling too long without seeing the water level change. | Laundry center | Whirlpool |
| F8E3 | Overflow F8E3 means the washer section measured a water level above the tub's capacity. | Laundry center | Whirlpool |
| F8E5 | Hot and cold reversed F8E5 means the washer section found the hot and cold water supplies connected backward. | Laundry center | Whirlpool |
| F9E1 | Long drain F9E1 means the washer section ran its drain pump for a long time but the water level did not change. | Laundry center | Whirlpool |