Whirlpool WFC310S0EW Front-load washer
Troubleshooting, fault codes and repair information for the Whirlpool WFC310S0EW, organized around the engineering platform this front-load washer is built on.
- Brand
- Whirlpool
- Model
- WFC310S0EW
- Engineering revisions
- WFC310S0EW, WFC310S0EW0, WFC310S0EW1, WFC310S0EW2, WFC310S0EW3, WFC310S0EW4
- Appliance
- Front-load washer
- Platform
- Front-load washer platform, documentation from about 2010
- Models on this platform
- 21 across Whirlpool
- Documented fault codes
- 0 with explanations, 5 more listed
- Service documentation
- Tech sheet (used by our technicians; not published)
Revision matters. Different engineering revisions of this model are documented on more than one platform. Confirm the full model number, including the last digit, on the model tag.
Whirlpool WFC310S0EW error codes
These are the fault codes documented for the platform this model belongs to. A code describes a condition the control detected; it does not by itself identify a failed part. Select a code for causes, safe checks and repair context.
| Code | Meaning | Areas involved |
|---|---|---|
| F1E0 | Internal board failure A/D Error(s) (explanation not yet published) | |
| F2E0 | Shorted key (explanation not yet published) | |
| F5E0 | Door and switches do not agree (Clean mode) (explanation not yet published) | |
| F5E1 | Door latch not operating (Clean mode) (explanation not yet published) | |
| F9E0 | Miswired house Miswired range (explanation not yet published) |
Common washer problems
- Not draining
- Not spinning
- Not filling
- Leaking
- Not starting
- Shaking or noisy
- Door or lid locked
- Stops mid-cycle
- Bad odor
Typical washer repair costs
| Repair | Typical range | Labor |
|---|---|---|
| Washer drain pump replacement | $180–$420 | Moderate |
| Washer water inlet valve replacement | $180–$360 | Light |
| Washer water-level pressure sensor repair | $180–$350 | Light |
| Front-load washer door lock replacement | $180–$400 | Moderate |
| Washer drive motor replacement | $300–$720 | Heavy |
| Washer motor control board replacement | $280–$600 | Moderate |
| Washer drive belt replacement | $180–$330 | Light |
| Washer suspension rods, springs or dampers replacement | $180–$440 | Moderate |
| Front-load washer tub bearing replacement | $550–$1,100 | Major |
| Front-load washer door boot seal replacement | $220–$510 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Repair or replace?
Washers typically last about 10–13 years. Service documentation for this platform dates from about 2010, so the oldest units built on it are now around 16 years old. The age printed in the serial number, the repair cost and the condition of the rest of the appliance decide it. Use the repair-or-replace guide.
Models built on the same platform
These models share this platform's service documentation, so fault codes and most diagnostic steps are the same.
- Whirlpool WFC130M0AB
- Whirlpool WFC130M0AW
- Whirlpool WFC130M0EB
- Whirlpool WFC130M0EW
- Whirlpool WFC150M0EB
- Whirlpool WFC150M0EW
- Whirlpool WFC150MLAB
- Whirlpool WFC150MLAW
- Whirlpool WFC150MLEB
- Whirlpool WFC150MLEW
- Whirlpool WFC310S0AB
- Whirlpool WFC310S0AS
- Whirlpool WFC310S0AT
- Whirlpool WFC310S0AW
- Whirlpool WFC310S0EB
- Whirlpool WFC310S0ES
- Whirlpool WFC315S0HB
- Whirlpool WFC315S0HS
- Whirlpool WFC315S0HT
- Whirlpool WFC315S0HW
Need your Whirlpool WFC310S0EW repaired in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.