Amana washer F8E6: water hazard (water with lid open)
F8E6 means the washer detected water in the tub while the lid had been left open for an extended time.
What F8E6 means
- Brand
- Amana
- Appliance
- Top-load washer
- Code
- F8E6
- Documented meaning
- Water hazard (water with lid open)
- Applies to
- 8 Amana models on 1 platform
- Can you keep using it?
- With caution
What the washer is detecting
An open lid with water in the tub is a safety concern, especially for children. If the control sees water and the lid open for too long (about ten minutes in the documentation), it stores F8E6 and may pump the water out.
Causes listed for this condition
In the order the service documentation checks them. Documented causes come from the manufacturer's service documentation for these platforms; possible causes are based on how the system works; unconfirmed marks common assumptions that the documentation does not support.
- Documented Lid left open with water in the tub.
- Documented A pinched, plugged or leaking pressure hose giving a false level reading.
- Documented A drain hose installed so it siphons.
- Documented An inlet valve letting water in when it should not.
- Documented A fault in the pressure sensor on the control.
- Documented A lid lock or lid switch problem.
Safe checks you can make
- Close the lid fully and make sure nothing (a towel edge, a dispenser cup, a hanging garment) is keeping it from seating on the cabinet.
- Check that the drain hose hangs loosely in the standpipe or laundry tub with an air gap around it, is not taped or sealed in, and is not pushed deep into the pipe; a sealed or deep hose can siphon water out while the washer fills.
Further diagnosis requires opening the appliance. Beyond the owner checks, diagnosis involves removing panels, testing components and checking wiring. We describe what a technician investigates, not how to do it yourself.
What a technician checks
- Runs the inlet valve, water-level and lid lock tests.
- Inspects the pressure hose.
Typical repairs and cost
Depending on what diagnosis finds, this code can lead to one of these repairs:
| Repair | Typical range | Labor |
|---|---|---|
| Washer water-level pressure sensor repair | $180–$350 | Light |
| Washer water inlet valve replacement | $180–$360 | Light |
| Top-load washer lid lock replacement | $180–$370 | Light |
| Washer main control board replacement | $300–$720 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Can you keep using it?
Use with caution. Close the lid and let the washer finish. If the code appears with the lid closed, or water appears in an idle washer, turn off the faucets and have it checked.
Amana models documented with this code
And 1 more. Use the model lookup to check yours.
Related problems and codes
Other codes documented on the same Amana platforms:
Repair or replace?
A fault code alone rarely justifies replacing a washer. Most F8E6 repairs involve a single component once diagnosed. Replacement becomes worth considering when the unit is near the end of its typical 10–13-year life and the diagnosed repair is a major one. See the repair-or-replace guide.
Need F8E6 diagnosed in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.