Whirlpool WED80HECW Electric dryer
Troubleshooting, fault codes and repair information for the Whirlpool WED80HECW, organized around the engineering platform this electric dryer is built on.
- Brand
- Whirlpool
- Model
- WED80HECW
- Engineering revisions
- WED80HECW0
- Appliance
- Electric dryer
- Platform
- Electric dryer platform, documentation from about 2010
- Models on this platform
- 193 across Amana, Crosley, Maytag, Whirlpool
- Documented fault codes
- 26 with explanations
- Service diagnostic mode
- Yes — a console-only test mode used by technicians to read stored codes and run component tests
- Service documentation
- Tech sheet, service manual (used by our technicians; not published)
Whirlpool WED80HECW error codes
These are the fault codes documented for the platform this model belongs to. A code describes a condition the control detected; it does not by itself identify a failed part. Select a code for causes, safe checks and repair context.
| Code | Meaning | Areas involved |
|---|---|---|
| F1E1 | Main control fault | Main control board, Wiring harness and connectors, Drive motor |
| F2E1 | Stuck button or interface problem | User interface / keypad board |
| F2E2 | User interface software error | User interface / keypad board, Wiring harness and connectors |
| F2E3 | Control programming error | Main control board, User interface / keypad board |
| F3E1 | Exhaust thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E2 | Exhaust thermistor shorted | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E3 | Inlet thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E4 | Inlet thermistor shorted | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E5 | Inlet and exhaust thermistors open | Wiring harness and connectors, Temperature sensor (thermistor), Main control board |
| F3E6 | Moisture sensor open | Moisture sensor bars, Wiring harness and connectors |
| F3E7 | Moisture sensor shorted | Moisture sensor bars, Wiring harness and connectors |
| F4E1 | Heat circuit or connector problem | Heating element, Gas valve and coils, Igniter |
| F4E3 | Restricted airflow | Exhaust vent duct, Blower wheel, Temperature sensor (thermistor) |
| F4E4 | L2 line voltage error | Wiring harness and connectors, Main control board |
| F6E1 | Communication error (control and interface) | Wiring harness and connectors, User interface / keypad board, Main control board |
| F6E2 | Communication error (control to interface) | Wiring harness and connectors, User interface / keypad board, Main control board |
| F01 | Primary control failure | Main control board |
| F02 | Keypad or user interface failure | User interface / keypad board |
| F22 | Exhaust thermistor open | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F23 | Exhaust thermistor shorted | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F26 | Motor drive system failure | Drive motor, Drive belt, Door switch |
| F28 | Moisture sensor open | Moisture sensor bars, Wiring harness and connectors |
| F29 | Moisture sensor shorted | Moisture sensor bars, Wiring harness and connectors |
| AF | Restricted airflow | Exhaust vent duct, Blower wheel |
| L2 | Low line voltage | Wiring harness and connectors, Main control board |
| PF | Power failure | Wiring harness and connectors |
Common dryer problems
Typical dryer repair costs
| Repair | Typical range | Labor |
|---|---|---|
| Dryer heating element replacement | $180–$400 | Moderate |
| Dryer thermal fuse and thermostat replacement | $180–$310 | Light |
| Dryer drive motor or blower wheel replacement | $250–$550 | Heavy |
| Dryer drum belt replacement | $180–$320 | Light |
| Dryer drum rollers, glides and idler pulley replacement | $190–$420 | Moderate |
| Dryer moisture sensor bar repair | $180–$310 | Light |
| Dryer door switch replacement | $180–$290 | Light |
| Dryer exhaust thermistor replacement | $180–$290 | Light |
| Dryer main control board replacement | $280–$640 | Moderate |
| Dryer user interface / keypad replacement | $230–$510 | Light |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Repair or replace?
Dryers typically last about 12–14 years. Service documentation for this platform dates from about 2010, so the oldest units built on it are now around 16 years old. The age printed in the serial number, the repair cost and the condition of the rest of the appliance decide it. Use the repair-or-replace guide.
Models built on the same platform
These models share this platform's service documentation, so fault codes and most diagnostic steps are the same.
- Whirlpool WED70HEBW
- Whirlpool WED71HEBW
- Whirlpool WED71HEDW
- Whirlpool WED72HEDW
- Whirlpool WED7505FW
- Whirlpool WED7540FW
- Whirlpool WED7590FW
- Whirlpool WED75HEFW
- Whirlpool WED7740FW
- Whirlpool WED77HEFW
- Whirlpool WED80HEBC
- Whirlpool WED80HEBW
- Whirlpool WED80HECC
- Whirlpool WED81HEDC
- Whirlpool WED81HEDW
- Whirlpool WED83HEDCB
- Whirlpool WED8540FW
- Whirlpool WED85HEFC
- Whirlpool WED85HEFW
- Whirlpool WED86HEBC
- Whirlpool WED86HEBW
- Whirlpool WED86HECC
- Whirlpool WED86HECR
- Whirlpool WED86HECW
- Whirlpool WED8740DC
- Whirlpool WED8740DW
- Whirlpool WED8740HEDC
- Whirlpool WED8740HEDW
- Whirlpool WED87HEBW
- Whirlpool WED87HEDC
Need your Whirlpool WED80HECW repaired in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.