Whirlpool WED9371YW Electric dryer
Troubleshooting, fault codes and repair information for the Whirlpool WED9371YW, organized around the engineering platform this electric dryer is built on.
- Brand
- Whirlpool
- Model
- WED9371YW
- Engineering revisions
- WED9371YW0, WED9371YW1
- Appliance
- Electric dryer
- Platform
- Electric dryer platform, documentation from about 2006
- Models on this platform
- 42 across Amana, Inglis, Maytag, Whirlpool
- Documented fault codes
- 18 with explanations
- Service diagnostic mode
- Yes — a console-only test mode used by technicians to read stored codes and run component tests
- Service documentation
- Tech sheet, service manual (used by our technicians; not published)
Whirlpool WED9371YW error codes
These are the fault codes documented for the platform this model belongs to. A code describes a condition the control detected; it does not by itself identify a failed part. Select a code for causes, safe checks and repair context.
| Code | Meaning | Areas involved |
|---|---|---|
| F1E1 | Main control fault | Main control board, Wiring harness and connectors, Drive motor |
| F2E1 | Stuck button or interface problem | User interface / keypad board |
| F3E1 | Exhaust thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E2 | Exhaust thermistor shorted | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E3 | Inlet thermistor fault | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F3E5 | Second (rear) moisture sensor fault | Moisture sensor bars, Wiring harness and connectors |
| F3E6 | Moisture sensor open | Moisture sensor bars, Wiring harness and connectors |
| F3E7 | Moisture sensor shorted | Moisture sensor bars, Wiring harness and connectors |
| F6E1 | Communication error (control and interface) | Wiring harness and connectors, User interface / keypad board, Main control board |
| F8E1 | Water valve failure (steam models) | Water inlet valve, Main control board |
| F01 | Primary control failure | Main control board |
| F02 | Keypad or user interface failure | User interface / keypad board |
| F22 | Exhaust thermistor open | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F23 | Exhaust thermistor shorted | Temperature sensor (thermistor), Wiring harness and connectors, Main control board |
| F26 | Motor drive system failure | Drive motor, Drive belt, Door switch |
| F28 | Moisture sensor open | Moisture sensor bars, Wiring harness and connectors |
| F29 | Moisture sensor shorted | Moisture sensor bars, Wiring harness and connectors |
| PF | Power failure | Wiring harness and connectors |
Common dryer problems
- Not heating
Documented check order on this platform: Heating element → Main control board - Not starting
Documented check order on this platform: Lid or door switch / lock → Drive belt → Power supply to the appliance → User interface / keypad → Main control board - Takes too long to dry
Documented check order on this platform: Moisture sensor → Temperature sensor → User interface / keypad → Main control board - Drum not turning
Documented check order on this platform: Drive belt → Power supply to the appliance → Lid or door switch / lock → Drive or pump motor → Main control board - Noisy
- Shuts off early
Documented check order on this platform: Exhaust vent restriction → Heating element → Moisture sensor - Overheating
Documented check order on this platform: Heating element
Typical dryer repair costs
| Repair | Typical range | Labor |
|---|---|---|
| Dryer heating element replacement | $180–$400 | Moderate |
| Dryer thermal fuse and thermostat replacement | $180–$310 | Light |
| Dryer drive motor or blower wheel replacement | $250–$550 | Heavy |
| Dryer drum belt replacement | $180–$320 | Light |
| Dryer drum rollers, glides and idler pulley replacement | $190–$420 | Moderate |
| Dryer moisture sensor bar repair | $180–$310 | Light |
| Dryer door switch replacement | $180–$290 | Light |
| Dryer exhaust thermistor replacement | $180–$290 | Light |
| Dryer main control board replacement | $280–$640 | Moderate |
| Dryer user interface / keypad replacement | $230–$510 | Light |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Repair or replace?
Dryers typically last about 12–14 years. Service documentation for this platform dates from about 2006, so the oldest units built on it are now around 20 years old. The age printed in the serial number, the repair cost and the condition of the rest of the appliance decide it. Use the repair-or-replace guide.
Models built on the same platform
These models share this platform's service documentation, so fault codes and most diagnostic steps are the same.
- Whirlpool WED9051YW
- Whirlpool WED9101YW
- Whirlpool WED9151YW
- Whirlpool WED9371YL
- Whirlpool YWED8300SB
- Whirlpool YWED8300SE
- Whirlpool YWED8300SW
- Whirlpool YWED8410SW
- Whirlpool YWED8500SR
- Whirlpool YWED9050XW
- Whirlpool YWED9101YW
- Whirlpool YWED9150WW
- Whirlpool YWED9151YW
- Whirlpool YWED9250WL
- Whirlpool YWED9250WR
- Whirlpool YWED9250WW
- Whirlpool YWED9270XL
- Whirlpool YWED9270XR
- Whirlpool YWED9270XW
- Whirlpool YWED9371YL
- Whirlpool YWED9371YW
- Inglis YIED7300WW
- Maytag YMED8400TB
- Maytag YMED8400TQ
- Maytag YMED8600TB
- Maytag YMED8600TK
- Maytag YMED8600TW
- Maytag YMEDE200XW
- Maytag YMEDE201YW
- Maytag YMEDE250XL
Need your Whirlpool WED9371YW repaired in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.