KitchenAid range F9E0: power supply miswired
F9E0 means the control detected that the electrical supply to the range or oven is connected incorrectly, for example neutral swapped with one of the hot lines.
What F9E0 means
- Brand
- KitchenAid
- Appliance
- Dual-fuel range, Electric range, Gas range
- Code
- F9E0
- Documented meaning
- Power supply miswired
- Applies to
- 89 KitchenAid models on 13 platforms
- Can you keep using it?
- No — stop and have it checked
What the range is detecting
At power-up the control checks the relationship between the supply conductors. When it sees a pattern that only a wiring mistake can produce, it stores F9E0 and may refuse to heat.
Causes listed for this condition
In the order the service documentation checks them. Documented causes come from the manufacturer's service documentation for these platforms; possible causes are based on how the system works; unconfirmed marks common assumptions that the documentation does not support.
- Documented House wiring or the power cord connected incorrectly at the appliance terminal block, such as neutral and a hot line reversed.
- Documented A house supply that does not provide the correct voltages.
- Documented A loose or damaged wire between the terminal block and the control.
Safe checks you can make
- If the appliance was recently installed, moved or had electrical work done, tell the installer or an electrician about the code, because it concerns how power is connected.
- Check whether a circuit breaker for the range or oven has tripped, or whether only one half of a double breaker is on.
This stage requires professional testing. Full diagnosis involves hazards such as live line voltage, gas, a sealed refrigerant system or microwave high voltage. Do not attempt it yourself.
What a technician checks
- This requires professional testing: verifying the house supply and the connection at the terminal block means measuring live 240-volt circuits.
- Checks the power cord or conduit connection at the appliance terminal block.
- Checks the wiring between the terminal block and the control.
Typical repairs and cost
Depending on what diagnosis finds, this code can lead to one of these repairs:
| Repair | Typical range | Labor |
|---|---|---|
| Range control board replacement | $300–$720 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Can you keep using it?
Stop using it until it is checked. Do not use the appliance until the power connection is checked by a qualified technician or electrician. A reversed or missing supply conductor can leave parts energized that should not be.
KitchenAid models documented with this code
- KFDC500HSS
- KFDC500JSS
- KFDC506HSS
- KFDC506JSS
- KFDC558HSS
- KFDC558JSS
- KFDD948SAG
- KFDD948SBE
- KFDD948SDC
- KFDD948SJP
- KFDD948SPL
- KFDD948SSC
- KFDD948SSS
- KFDD948SWF
- KFEG500EBL
- KFEG500EBS
And 73 more. Use the model lookup to check yours.
Related problems and codes
Other codes documented on the same KitchenAid platforms:
Repair or replace?
A fault code alone rarely justifies replacing a range. Most F9E0 repairs involve a single component once diagnosed. Replacement becomes worth considering when the unit is near the end of its typical 13–17-year life and the diagnosed repair is a major one. See the repair-or-replace guide.
Need F9E0 diagnosed in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.