Maytag washer F9E2: unable to drain water from load
F9E2 means the washer could not remove the water held in the load, indicating a problem in the drain system.
What F9E2 means
- Brand
- Maytag
- Appliance
- Top-load washer
- Code
- F9E2
- Documented meaning
- Unable to drain water from load
- Applies to
- 18 Maytag models on 2 platforms
- Can you keep using it?
- With caution
What the washer is detecting
After draining, the control checks for water still trapped in and around the load. If it cannot get the water out, F9E2 is stored.
Causes listed for this condition
In the order the service documentation checks them. Documented causes come from the manufacturer's service documentation for these platforms; possible causes are based on how the system works; unconfirmed marks common assumptions that the documentation does not support.
- Documented A clogged drain hose or drain pump.
- Documented A drain hose outlet set too high above the floor.
- Documented A pinched, plugged or leaking pressure hose.
- Documented Too much detergent.
- Documented A drain pump that does not run, checked with the pump test.
Safe checks you can make
- Check the drain hose for kinks and confirm its outlet is not higher than the installation instructions allow.
- Use only HE detergent, measured for the load size and soil level; cut back if you see heavy suds in the tub.
- Run a Drain & Spin with the basket empty to see whether the water leaves.
Further diagnosis requires opening the appliance. Beyond the owner checks, diagnosis involves removing panels, testing components and checking wiring. We describe what a technician investigates, not how to do it yourself.
What a technician checks
- Runs the drain pump test.
- Checks the pump inlet and the pressure hose.
Typical repairs and cost
Depending on what diagnosis finds, this code can lead to one of these repairs:
| Repair | Typical range | Labor |
|---|---|---|
| Washer drain pump replacement | $180–$420 | Moderate |
| Washer water-level pressure sensor repair | $180–$350 | Light |
| Washer main control board replacement | $300–$720 | Moderate |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Can you keep using it?
Use with caution. Loads will come out wet. If the hose and detergent checks do not fix it, have the drain system checked.
Maytag models documented with this code
- MVWB755DW
- MVWB757JW
- MVWB765FC
- MVWB765FW
- MVWB766FW
- MVWB835DC
- MVWB835DW
- MVWB855DC
- MVWB855DW
- MVWB865FC
- MVWB865FW
- MVWB865GC
- MVWB865GW
- MVWB955FC
- MVWB955FS
- MVWB955FW
And 2 more. Use the model lookup to check yours.
Related problems and codes
Other codes documented on the same Maytag platforms:
Repair or replace?
A fault code alone rarely justifies replacing a washer. Most F9E2 repairs involve a single component once diagnosed. Replacement becomes worth considering when the unit is near the end of its typical 10–13-year life and the diagnosed repair is a major one. See the repair-or-replace guide.
Need F9E2 diagnosed in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.