Repair cost
Maytag washer washer main control board replacement cost
A washer main control board replacement on a Maytag washer typically costs $300–$720 in the Las Vegas area, parts and labor included. Replacing the electronic control that runs washer cycles, reads sensors and switches the pump, valves and motor.
- Repair
- Washer main control board replacement
- Typical range
- $300–$720
- Labor
- Moderate
- Diagnosis required first
- Yes
Final cost depends on diagnosis, the exact model, parts availability and whether other damage is found. This is a typical range based on similar repairs, not a quote.
What the repair includes
- Diagnosis to confirm the failed part before ordering
- Ruling out loads, harness and sensor faults before condemning the board
- Board replacement and model configuration where required
- Full cycle test
Why the price varies
- Board part cost for the platform
- Whether a shorted load (pump, valve, motor) damaged the old board
- Configuration step on some platforms
When this repair makes sense
- Washer is under roughly 8 years old and mechanically sound
- Board failure is confirmed and the cause is identified
When replacement may be the better choice
- Washer is older with bearing, gearcase or suspension wear
- Board is discontinued for the model
Signs the main control board may not be the problem
- A shorted valve, pump or motor can make a good board look dead or damage a new one; loads are checked first.
- Power problems such as a tripped breaker, a loose outlet or a GFCI give the same no-power symptom.
- A loose harness connector or rodent-chewed wire mimics an intermittent board.
- Error codes report a condition the control detected; a code does not mean the board is bad.
Maytag error codes that can lead to this repair
These codes are documented with this component among the possible causes. A code alone does not confirm the part has failed.
- F0E2
- F0E3
- F0E4
- F0E6
- F1E1
- F1E2
- F1E3
- F1E6
- F1E7
- F2E2
- F2E3
- F3E1
- F3E2
- F3E2-1
- F3E3
- F3E4
- F3E6
- F3E7
- F3E8
- F4E1
- F4E2
- F4E3
- F5E1
- F5E2
- F5E3
- F6E1
- F6E2
- F6E3
- F7E0
- F7E1
Related problems
- Washer won't start
- Washer stops mid-cycle
- Washer not spinning
- Washer not filling with water
- Washer not draining
Get a firm price after diagnosis
A technician confirms whether the main control board is really the problem before any part is replaced. Serving Las Vegas, Henderson, Summerlin and Boulder City.