Roper washer F1E2: motor control fault
F1E2 means the main control found a fault in its own motor-control section, the part of the board that drives the washer motor.
What F1E2 means
- Brand
- Roper
- Appliance
- Top-load washer
- Code
- F1E2
- Documented meaning
- Motor control fault
- Applies to
- 9 Roper models on 5 platforms
- Can you keep using it?
- No — stop and have it checked
What the washer is detecting
On these models the electronics that run the motor are part of the main control. When that section reports an internal fault, F1E2 is stored and the motor is stopped.
Causes listed for this condition
In the order the service documentation checks them. Documented causes come from the manufacturer's service documentation for these platforms; possible causes are based on how the system works; unconfirmed marks common assumptions that the documentation does not support.
- Documented A fault in the motor-control circuitry of the main control.
- Documented A motor or motor wiring problem that the motor test is used to rule out.
Safe checks you can make
- Unplug the washer for one minute, plug it back in and start a new cycle. If the code comes straight back, the condition is persistent and needs diagnosis.
This stage requires professional testing. Full diagnosis involves hazards such as live line voltage, gas, a sealed refrigerant system or microwave high voltage. Do not attempt it yourself.
What a technician checks
- Runs the drive-motor test from service diagnostics.
- Checks the motor and its harness before replacing the control.
Typical repairs and cost
Depending on what diagnosis finds, this code can lead to one of these repairs:
| Repair | Typical range | Labor |
|---|---|---|
| Washer main control board replacement | $300–$720 | Moderate |
| Washer drive motor replacement | $300–$720 | Heavy |
Typical total ranges for the Las Vegas area, parts and labor included. The final cost depends on diagnosis, the exact model, parts availability and whether other damage is found.
Can you keep using it?
Stop using it until it is checked. Stop using the washer if the code returns after a power reset. Motor drive electronics can hold stored energy, so this requires professional testing.
Roper models documented with this code
And 2 more. Use the model lookup to check yours.
Related problems and codes
Other codes documented on the same Roper platforms:
Repair or replace?
A fault code alone rarely justifies replacing a washer. Most F1E2 repairs involve a single component once diagnosed. Replacement becomes worth considering when the unit is near the end of its typical 10–13-year life and the diagnosed repair is a major one. See the repair-or-replace guide.
Need F1E2 diagnosed in the Las Vegas area?
We repair Whirlpool, Maytag, KitchenAid, JennAir, Amana and other Whirlpool-family appliances in Las Vegas, Henderson, Summerlin and Boulder City. A model number helps but is never required to book.